halftrackinfo

general discussion => ALL mechanical and technical related questions => Topic started by: emptyhead on November 06, 2016, 10:44:42 AM

Title: Radiator armor
Post by: emptyhead on November 06, 2016, 10:44:42 AM

I just slide the radiator in and was fusing around with the radiator armor and found that it's sitting lower than the radiator. Have any of you guys had to shim under your side brackets that bolt to the frame or ran into any that where shimmed. Thanks

Title: Re: Radiator armor
Post by: steve1973 on November 12, 2016, 06:40:22 AM

Did you try to adjust the two side radiator support rods to lay the radiator back some? be carful of the fan hitting the shroud when doing this. You should not have to shim up your radiator armor.

Steve A.

Title: Re: Radiator armor
Post by: emptyhead on November 13, 2016, 06:14:37 AM

Thanks steve I pulled the radiator out and took another look at the bottom support and sure enough there was a send in it. Don't know how the last guy manage that. Put it back in will check with the center piece of amor but looks better after bending support.