halftrackinfo

general discussion => ALL mechanical and technical related questions => Topic started by: Cleprechaun on April 18, 2018, 10:22:58 PM

Title: Louvre lever / slays lever
Post by: Cleprechaun on April 18, 2018, 10:22:58 PM

I have a massive rust hole right where the lever should mount and the bottom end of my lever is a rusty lump. I would greatly appreciate a few good photos of this mounting point and any details you could give me on the end of the lever (pivot hardware)

Title: Re: Louvre lever / slays lever
Post by: steve1973 on April 19, 2018, 02:14:59 AM

I will get some photos next time I'm at the shop.
Steve A.

Title: Re: Louvre lever / slays lever
Post by: 8683jb on April 19, 2018, 09:41:02 AM

Here are some pictures:

(http://www.surfacezero.com/g503/data/500/medium/20180419_080531.jpg)

(http://www.surfacezero.com/g503/data/500/medium/20180419_080516.jpg)


I couldn't see the other end, but it looks like the lever attaches with a rivet rather than a bolt:
(http://www.surfacezero.com/g503/data/500/medium/20180419_080506.jpg)

(http://www.surfacezero.com/g503/data/500/medium/20180419_080438.jpg)



I hope this helps. Let me know if you need more.
Jon

Title: Re: Louvre lever / slays lever
Post by: Cleprechaun on April 19, 2018, 09:30:58 PM

Wonderful, thanks !