halftrackinfo

armor plate => fenders, door hardware and other body parts (non armor) => Topic started by: 8683jb on July 03, 2018, 07:08:55 PM

Title: WTB M2A1 floor panels
Post by: 8683jb on July 03, 2018, 07:08:55 PM

I’m looking to buy two floor panels for my M2A1. One is the center, rear panel in the cab, under the feet of the guy in the middle seat. It measures 20-3/4” x 12-3/4”and the centers of the three holes along the rear edge are 1” from the edge. It has a place in the right front corner for the attach point for the right-hand seat prop. The other panel is under the front-facing and rear-facing middle seats, at the front of the bed. It measures approx. 33-3/4” x 21-3/4” and has a hole for the pulpit post on the right side and a hole for the antenna on the left side. Either steel or aluminum is fine. Does anyone have an extra of either or both? Thanks.
Jon

Title: Re: WTB M2A1 floor panels
Post by: yd328 on July 04, 2018, 01:29:35 PM

I thought Rod Shaver had the bed piece in Louisville, it was aluminum.

Gary

Title: Re: WTB M2A1 floor panels
Post by: 8683jb on July 04, 2018, 07:41:31 PM

Thanks Gary. I'll get with him.

Title: Re: WTB M2A1 floor panels
Post by: warbirdrestorer on July 07, 2018, 08:20:55 AM

Hey Jon,
Did you ever find the panels you need? I’m sure I have them in steel or aluminum.

Mike

Title: Re: WTB M2A1 floor panels
Post by: 8683jb on July 07, 2018, 09:02:41 AM

No I haven't Mike. I'll email you. Thanks.

Title: Re: WTB M2A1 floor panels
Post by: 8683jb on July 19, 2018, 01:44:41 PM

I meant to ask if anyone has the small plate that goes over the master cylinder in the driver's side floor? The floor is aluminum. Thanks.
Jon