halftrackinfo

armor plate => fenders, door hardware and other body parts (non armor) => Topic started by: bright87 on May 24, 2014, 10:33:37 PM

Title: M2 grab handles
Post by: bright87 on May 24, 2014, 10:33:37 PM

Hey guys-
Anyone have size and location of the two grab handles on the rear armor (near the top and sides) on a M2?
Thanks-Michael

Title: Re: M2 grab handles
Post by: andy on May 26, 2014, 05:51:00 AM

Are they the same on a m2a1?
from the top down the top of the handle is at 7 inch at the handles half point, bottom is 12 inch at half point on handle. The handle is 2 1/4 in from the edge to mid point on handle

Andy

Title: Re: M2 grab handles
Post by: BombFarm on May 27, 2014, 05:44:17 PM

Michael,
Not sure if your wanting the handles too? Here is a drawing I made of my handles. I believe them to be reproductions. Hope it helps.

Title: Re: M2 grab handles
Post by: Torque on May 27, 2014, 06:56:11 PM

Thanks Bombfarm, I was going to make these the other day, luckily I was out of 1/2" cold rolled and wasn't able to make them, they would have been wrong.

Title: Re: M2 grab handles
Post by: bright87 on May 28, 2014, 06:15:08 PM

Thanks guys! That's everything I need for that project.
Michael

Title: Re: M2 grab handles
Post by: Smadge on June 11, 2019, 12:35:52 PM

Anybody making these?  I need two!!!!!!

Title: Re: M2 grab handles
Post by: Chrishig on June 11, 2019, 05:02:09 PM

If they are the same as the ones on the back of an M3 I need 3 of them .