halftrackinfo

armor plate => m2/ m2A1 rear armor and bed => Topic started by: steve1973 on April 10, 2015, 09:07:35 PM

Title: M2 Mine Rack Drawings
Post by: steve1973 on April 10, 2015, 09:07:35 PM
Hello all. I spent a few hours at the shop today making some drawings of my mine racks. All the measurements are within 1/16 of an inch accurate I believe.

(http://www.surfacezero.com/g503/data/500/Mine_Racks_1.jpg)

(http://www.surfacezero.com/g503/data/500/Mine_Racks_2.jpg)

(http://www.surfacezero.com/g503/data/500/Mine_Racks_3.jpg)

(http://www.surfacezero.com/g503/data/500/Mine_Racks_4.jpg)

Photos

(http://www.surfacezero.com/g503/data/500/medium/DSCN23862.JPG)

(http://www.surfacezero.com/g503/data/500/medium/DSCN23873.JPG)

(http://www.surfacezero.com/g503/data/500/medium/DSCN23881.JPG)

(http://www.surfacezero.com/g503/data/500/medium/DSCN23891.JPG)

In this photo you can clearly see the channel cut out in the lower corner but I don't think it is necessary.

(http://www.surfacezero.com/g503/data/500/medium/DSCN2390.JPG)

(http://www.surfacezero.com/g503/data/500/medium/DSCN2392.JPG)

(http://www.surfacezero.com/g503/data/500/medium/DSCN23931.JPG)

(http://www.surfacezero.com/g503/data/500/medium/DSCN2396.JPG)

(http://www.surfacezero.com/g503/data/500/medium/DSCN23971.JPG)

(http://www.surfacezero.com/g503/data/500/medium/DSCN23951.JPG)

(http://www.surfacezero.com/g503/data/500/medium/DSCN2394.JPG)

Steve A.

Title: Re: M2 Mine Rack Drawings
Post by: col.halftrack on April 11, 2015, 08:42:30 AM
Wow well Done Sir.