halftrackinfo
fuel system => carburetor and linkage => Topic started by: andy on April 29, 2014, 08:07:50 PM
-
Anyone have a pic of the bracket on the carb for the throttle cable. Im hooking up the cables from the dash and it seems there should be one,
Thanks,
Andy
-
http://www.mcmaster.com/#96995a160/=rdd1fz
try this link it was posted in this section in a thread about throttle return springs.
-
Thanks, I need that too, but im looking for a pic of the bracket that holds the cable for the throttle cable from the dash to the carb.
-
I just happen to be working on the carb so I got a pic. I'll try to post from my computer tomorrow. Brkt is flat steel strip 3/4" wide with hole spacing 2 5/8. One hole for 1/4 bolt other 5/16 bolt. Carb end angled to contour around carb baseplate. Strip appears to be about .10 thick whatever gage that is(10?)
-
Although you can't see the back of the carb where the bracket mounts, at least you can see most of the bracket itself. I hope between autocar925's description and this picture you will get what you need.
*Picture from Tim Sutter's M2.
-
Bracket
-
Perfect guys a big thanks!
Andy