paper gaskets

[bright87]

On paper gaskets such as the transmission/transfer case, do we use any type of sealer?
I have always just wiped a thin film of black gasket gook on them, but do I really need to?
Michael

[Monkeypirate]

I have found that putting a bit of RTV on the gasket is an easy way to make sure that it seals and that it comes off when the time comes.  Ive had good luck with it all around. But as long as the parts are clean and strait, Ive never had a problem with a paper gasket leaking for years. Ive also used RTV on one side and lithium on the other for cork gaskets.  Allows you to take off valve covers or inspection plates without destroying the gasket.But this is just my opinion. Im sure every one has their way of doing it that is right or wrong. As i see it though. If it works good and doesn't cause damage. No harm in being a little on the safe side.

[andy]

I always do put a sealant on bothsides of gaskets. I restore alot of old vehicle parts that are usually pitted to a degree and its always a safer precaution. Usually if the surface is good i use a putty knife and spread a very thin layer on it just to cover it and make it tacky. Also helps to hold it in place

Andy

[bright87]

Thanks guys for the replies. This is basically how I have always done it, just checking.
I did see a tube of paper/cork gasket adhesive at Autozone, but I did not use it.
Michael