Author Topic: M3 in St. Louis MO  (Read 40513 times)

Darth_Kitten

  • Full Member
  • ***
  • Posts: 240
Re: M3 in St. Louis MO
« Reply #165 on: February 21, 2018, 07:55:42 PM »
It's so cold and cruddy here now. Progress is slow. Have the front horizontal armor bolted up now. I've noticed in some photos a large ish hole that would be under the fuel tank (I'm guessing for a drain or plumbing) Would anyone have any measurements for that hole location and size? Am I missing anything else?

emptyhead

  • Sr. Member
  • ****
  • Posts: 376
Re: M3 in St. Louis MO
« Reply #166 on: February 25, 2018, 06:32:14 AM »
I’ll measure it for you this morning and get back to you

emptyhead

  • Sr. Member
  • ****
  • Posts: 376
Re: M3 in St. Louis MO
« Reply #167 on: February 25, 2018, 08:07:31 AM »
Here are the measurements I got off my track armor.mine is an m16 but it’s all the same. From the bulkhead to center of the hole 22 and 5/8, from the seat side of the track armor edge to the center of the hole it’s 9 and 1/2 . Hole diameter 1 and 3/4. Hope that helps

Darth_Kitten

  • Full Member
  • ***
  • Posts: 240
Re: M3 in St. Louis MO
« Reply #168 on: February 26, 2018, 11:03:42 AM »
Thanks!

Here are the measurements I got off my track armor.mine is an m16 but it’s all the same. From the bulkhead to center of the hole 22 and 5/8, from the seat side of the track armor edge to the center of the hole it’s 9 and 1/2 . Hole diameter 1 and 3/4. Hope that helps