bulkhead fitting (through the frame) for pedestal headlight wiring harness

[steve-0]

has anyone found a good source for the bulkhead fitting (through the frame) for pedestal headlight wiring harness? they seem to always to be bad.

edit…..  i had listed the wrong size so i am editing this post so there is no confusion.

the correct size is 11/16-24    thanks emptyhead

[emptyhead]

Anyone found a source for nuts for the bulkhead fitting. I took the fitting down to local plumbing shop that always has hard to find stuff and no luck with anything. Looks to be 11/16 x 24. All the stuff on line offered in that size is rediculous. Thanks

[steve-0]

thanks for the correction on the size.

here are some nuts
https://www.google.com/search?client=safari&rls=en&q=%2211/16-24%22+nut&ie=UTF-8&oe=UTF-8#q=%2211/16-24%22+nut&tbm=shop

http://www.finditparts.com/products/619523/haltec-b-222?srcid=CHL01SCL010-Npla-Dmdt-Gusa-Svbr-Mmuu-K619523&gclid=CMCA65aRwcsCFYqPfgodD2MNmQ

http://www.partdeal.com/wexco-11-16-in-nut-for-wiper-pivot-shaft-300756.html?zmam=74973193&zmas=1&zmac=4&zmap=77129802&gclid=CJ3S6qmRwcsCFcNlfgodHsYNLA

[steve-0]

check this out.

its 11/16-24

T-82 by HALTEC
Clamp-In Spud

http://www.finditparts.com/products/617556/haltec-t-82

http://www.vampa.net/product_p/ext-82.htm

[emptyhead]

Thanks steve I ordered a couple of nuts will let you know how they work out. That other fitting looks like a very good substitute.

[spec4don]

I ended up ordering a piece of hex brass and drilled and tapped my own. If it doesn't work out let me know I have a couple of extra.

Don G.

[emptyhead]

Thanks steve I picked up a couple of the brass nuts and they work just great it was still cheaper even with shipping. Don thank you for the offer.much appreciated.

[steve-0]

your welcome.

the nut for the dash light is 11/16-32
it might work for others in a hurry.