WTB M2A1 floor panels

[8683jb]

I’m looking to buy two floor panels for my M2A1. One is the center, rear panel in the cab, under the feet of the guy in the middle seat. It measures 20-3/4” x 12-3/4”and the centers of the three holes along the rear edge are 1” from the edge. It has a place in the right front corner for the attach point for the right-hand seat prop. The other panel is under the front-facing and rear-facing middle seats, at the front of the bed. It measures approx. 33-3/4” x 21-3/4” and has a hole for the pulpit post on the right side and a hole for the antenna on the left side. Either steel or aluminum is fine. Does anyone have an extra of either or both? Thanks.
Jon

[yd328]

I thought Rod Shaver had the bed piece in Louisville, it was aluminum.

Gary

[8683jb]

Thanks Gary. I'll get with him.

[warbirdrestorer]

Hey Jon,
Did you ever find the panels you need? I’m sure I have them in steel or aluminum.

Mike

[8683jb]

No I haven't Mike. I'll email you. Thanks.

[8683jb]

I meant to ask if anyone has the small plate that goes over the master cylinder in the driver's side floor? The floor is aluminum. Thanks.
Jon