Author Topic: WTB M2A1 floor panels  (Read 188 times)

8683jb

  • Sr. Member
  • ****
  • Posts: 320
WTB M2A1 floor panels
« on: July 03, 2018, 07:08:55 PM »
I’m looking to buy two floor panels for my M2A1. One is the center, rear panel in the cab, under the feet of the guy in the middle seat. It measures 20-3/4” x 12-3/4”and the centers of the three holes along the rear edge are 1” from the edge. It has a place in the right front corner for the attach point for the right-hand seat prop. The other panel is under the front-facing and rear-facing middle seats, at the front of the bed. It measures approx. 33-3/4” x 21-3/4” and has a hole for the pulpit post on the right side and a hole for the antenna on the left side. Either steel or aluminum is fine. Does anyone have an extra of either or both? Thanks.
Jon
'42 Autocar M2A1

MVPA member

yd328

  • Hero Member
  • *****
  • Posts: 526
Re: WTB M2A1 floor panels
« Reply #1 on: July 04, 2018, 01:29:35 PM »
I thought Rod Shaver had the bed piece in Louisville, it was aluminum.

Gary

8683jb

  • Sr. Member
  • ****
  • Posts: 320
Re: WTB M2A1 floor panels
« Reply #2 on: July 04, 2018, 07:41:31 PM »
Thanks Gary. I'll get with him.
'42 Autocar M2A1

MVPA member

warbirdrestorer

  • Newbie
  • *
  • Posts: 24
Re: WTB M2A1 floor panels
« Reply #3 on: July 07, 2018, 08:20:55 AM »
Hey Jon,
Did you ever find the panels you need? I’m sure I have them in steel or aluminum.

Mike

8683jb

  • Sr. Member
  • ****
  • Posts: 320
Re: WTB M2A1 floor panels
« Reply #4 on: July 07, 2018, 09:02:41 AM »
No I haven't Mike. I'll email you. Thanks.
'42 Autocar M2A1

MVPA member