Author Topic: Master Cylinder Cover (Floor)  (Read 474 times)

mkoloc

  • Full Member
  • ***
  • Posts: 153
Master Cylinder Cover (Floor)
« on: February 11, 2020, 08:47:13 PM »
Does anyone have a cover for the master cylinder... talking about the cover that sits on the drivers floor... that is removed to fill the master cylinder  .. or a pic of one so that I might be able to fabricate one up.

Thanks,
Mark
Mark A.R. Koloc Sr.
LTC USA (RET)
1631 Bitter Creek Lane
Batavia, OH  45103
Cell:  715-821-9426

8683jb

  • Hero Member
  • *****
  • Posts: 662
Re: Master Cylinder Cover (Floor)
« Reply #1 on: February 12, 2020, 09:13:12 AM »
Alan Wing made this one for me out of scrap alum. floor plate. The screws are 10-32. I hope this helps.

Jon







'42 Autocar M2A1

MVPA member

steve1973

  • Hero Member
  • *****
  • Posts: 1313
Re: Master Cylinder Cover (Floor)
« Reply #2 on: February 12, 2020, 10:33:05 AM »
Alan Wing made this one for me out of scrap alum. floor plate. The screws are 10-32. I hope this helps.

Jon








The best way to get a cover plate is to cut up a scrap or extra plate as Jon did.

Steve A.