Need clutch reassembly info

[8683jb]

Can anyone confirm that when reassembling the clutch, the wood blocks used between the flywheel ring and the throwout bearing are ⅜” thick, as per TM 9-1711? The blocks used for the disassembly are ¾”, not ⅜” and the blocks shown in Fig. 12 sure look more like ¾ than ⅜. Is it a typo or is ⅜ a good number?
 
Thanks.

Jon

[Smadge]

Jon,

3/4"

Paul

[8683jb]

Thanks so much Paul!

[Smadge]

Jon,

TM 9-710. Top of page 159

Hope you guys are doing well with everything going on!

Paul

[8683jb]

Thanks again Paul. I used that info for the removal and it didn't make sense that 3/8" would be used to go back in. I appreciate the help! I hope you guys are well too. Just have to lay low for a while, I guess.

[ph5200]

I have the engine and transmission separted.  I did not put any blocks between the throw out bearing and cutch.  I need some info on how to replace the throw out bearing. Thanks

[8683jb]

The info you need is in TM 9-710 and TM 9-1711. I think you can see them both online as a pdf.

Jon