Author Topic: Need clutch reassembly info  (Read 313 times)

8683jb

  • Hero Member
  • *****
  • Posts: 635
Need clutch reassembly info
« on: March 21, 2020, 05:41:10 PM »
Can anyone confirm that when reassembling the clutch, the wood blocks used between the flywheel ring and the throwout bearing are ⅜” thick, as per TM 9-1711? The blocks used for the disassembly are ¾”, not ⅜” and the blocks shown in Fig. 12 sure look more like ¾ than ⅜. Is it a typo or is ⅜ a good number?
 
Thanks.

Jon






« Last Edit: March 21, 2020, 05:52:19 PM by 8683jb »
'42 Autocar M2A1

MVPA member

Smadge

  • Full Member
  • ***
  • Posts: 245
Re: Need clutch reassembly info
« Reply #1 on: March 21, 2020, 07:28:04 PM »
Jon,

3/4"

Paul
1941 M2 Autocar (restoring)
MVPA# 36810E

8683jb

  • Hero Member
  • *****
  • Posts: 635
Re: Need clutch reassembly info
« Reply #2 on: March 21, 2020, 07:31:41 PM »
Thanks so much Paul!
'42 Autocar M2A1

MVPA member

Smadge

  • Full Member
  • ***
  • Posts: 245
Re: Need clutch reassembly info
« Reply #3 on: March 21, 2020, 07:36:16 PM »
Jon,

TM 9-710. Top of page 159

Hope you guys are doing well with everything going on!

Paul
1941 M2 Autocar (restoring)
MVPA# 36810E

8683jb

  • Hero Member
  • *****
  • Posts: 635
Re: Need clutch reassembly info
« Reply #4 on: March 21, 2020, 09:08:14 PM »
Thanks again Paul. I used that info for the removal and it didn't make sense that 3/8" would be used to go back in. I appreciate the help! I hope you guys are well too. Just have to lay low for a while, I guess.
'42 Autocar M2A1

MVPA member

ph5200

  • Newbie
  • *
  • Posts: 9
Re: Need clutch reassembly info
« Reply #5 on: March 22, 2020, 09:55:37 AM »
I have the engine and transmission separted.  I did not put any blocks between the throw out bearing and cutch.  I need some info on how to replace the throw out bearing. Thanks

8683jb

  • Hero Member
  • *****
  • Posts: 635
Re: Need clutch reassembly info
« Reply #6 on: March 22, 2020, 08:41:37 PM »
The info you need is in TM 9-710 and TM 9-1711. I think you can see them both online as a pdf.

Jon
'42 Autocar M2A1

MVPA member