Author Topic: winch grease fittings  (Read 265 times)

ph5200

  • Newbie
  • *
  • Posts: 15
winch grease fittings
« on: November 01, 2020, 12:46:01 PM »
I asked this question on another site but I am going to ask it again.  Are the grease fittings in the winch press in or screw in.  I tried to screw one out to replace it and couldn't get it to screw out.  Used an air hammer to break it out. I think they have to be press in.  If they are press in what is the best way to get them out.  Can you press the same size back in the hole?

8683jb

  • Hero Member
  • *****
  • Posts: 681
Re: winch grease fittings
« Reply #1 on: November 01, 2020, 04:29:43 PM »
I've been able to get them out with an Ez-Out.
'42 Autocar M2A1

MVPA member