Author Topic: M2 grab handles  (Read 1590 times)

bright87

  • Full Member
  • ***
  • Posts: 138
M2 grab handles
« on: May 24, 2014, 10:33:37 PM »
Hey guys-
Anyone have size and location of the two grab handles on the rear armor (near the top and sides) on a M2?
Thanks-Michael

andy

  • Sr. Member
  • ****
  • Posts: 369
Re: M2 grab handles
« Reply #1 on: May 26, 2014, 05:51:00 AM »
Are they the same on a m2a1?
from the top down the top of the handle is at 7 inch at the handles half point, bottom is 12 inch at half point on handle. The handle is 2 1/4 in from the edge to mid point on handle

Andy
« Last Edit: May 26, 2014, 02:33:00 PM by andy »
1943 M4A1 (restored to M2A1)

BombFarm

  • Newbie
  • *
  • Posts: 37
Re: M2 grab handles
« Reply #2 on: May 27, 2014, 05:44:17 PM »
Michael,
Not sure if your wanting the handles too? Here is a drawing I made of my handles. I believe them to be reproductions. Hope it helps.

Torque

  • Full Member
  • ***
  • Posts: 178
Re: M2 grab handles
« Reply #3 on: May 27, 2014, 06:56:11 PM »
Thanks Bombfarm, I was going to make these the other day, luckily I was out of 1/2" cold rolled and wasn't able to make them, they would have been wrong.

bright87

  • Full Member
  • ***
  • Posts: 138
Re: M2 grab handles
« Reply #4 on: May 28, 2014, 06:15:08 PM »
Thanks guys! That's everything I need for that project.
Michael

Smadge

  • Full Member
  • ***
  • Posts: 170
Re: M2 grab handles
« Reply #5 on: June 11, 2019, 12:35:52 PM »
Anybody making these?  I need two!!!!!!
1941 M2A1 Autocar (restoring)
MVPA# 36810E

Chrishig

  • Newbie
  • *
  • Posts: 15
  • 978-618-9464
Re: M2 grab handles
« Reply #6 on: June 11, 2019, 05:02:09 PM »
If they are the same as the ones on the back of an M3 I need 3 of them .
M3 in pieces
M2 in pieces
M15A1 becoming an M3
M38
GPW
M923A2