halftrackinfo

armor plate => m3/m3A1/m16A1 rear armor and bed => Topic started by: Darth_Kitten on July 12, 2018, 08:38:53 AM

Title: floor panel needed
Post by: Darth_Kitten on July 12, 2018, 08:38:53 AM

Hi All,
Looking for the forward troop compartment panel that goes over the pedestal mount.
Anyone have an extra laying around?

Title: Re: floor panel needed
Post by: Outsider on July 12, 2018, 03:37:44 PM

I have a repro plate and the angle iron that mounts in the front that the plate goes to available.

steve

Title: Re: floor panel needed
Post by: Outsider on July 12, 2018, 03:38:40 PM

Also looking at your cross member your HT was an A1 at one time.
Steve

Title: Re: floor panel needed
Post by: Darth_Kitten on July 12, 2018, 04:08:20 PM

Thanks Steve, I'll send you a message on the floor. I figured you would have it since you make the beds.
The cross member is not original to this track. Everything from the cab back was purchased in a parts lot a while back.

Quote from: Outsider on July 12, 2018, 03:38:40 PM

Also looking at your cross member your HT was an A1 at one time.
Steve