halftrackinfo

drive train => clutch => Topic started by: 8683jb on March 21, 2020, 05:41:10 PM

Title: Need clutch reassembly info
Post by: 8683jb on March 21, 2020, 05:41:10 PM

Can anyone confirm that when reassembling the clutch, the wood blocks used between the flywheel ring and the throwout bearing are ⅜” thick, as per TM 9-1711? The blocks used for the disassembly are ¾”, not ⅜” and the blocks shown in Fig. 12 sure look more like ¾ than ⅜. Is it a typo or is ⅜ a good number?
 
Thanks.

Jon

(http://www.surfacezero.com/g503/data/500/medium/20200321_160943_LI.jpg)

(http://www.surfacezero.com/g503/data/500/medium/20200321_161040_LI.jpg)

Title: Re: Need clutch reassembly info
Post by: Smadge on March 21, 2020, 07:28:04 PM

Jon,

3/4"

Paul

Title: Re: Need clutch reassembly info
Post by: 8683jb on March 21, 2020, 07:31:41 PM

Thanks so much Paul!

Title: Re: Need clutch reassembly info
Post by: Smadge on March 21, 2020, 07:36:16 PM

Jon,

TM 9-710. Top of page 159

Hope you guys are doing well with everything going on!

Paul

Title: Re: Need clutch reassembly info
Post by: 8683jb on March 21, 2020, 09:08:14 PM

Thanks again Paul. I used that info for the removal and it didn't make sense that 3/8" would be used to go back in. I appreciate the help! I hope you guys are well too. Just have to lay low for a while, I guess.

Title: Re: Need clutch reassembly info
Post by: ph5200 on March 22, 2020, 09:55:37 AM

I have the engine and transmission separted.  I did not put any blocks between the throw out bearing and cutch.  I need some info on how to replace the throw out bearing. Thanks

Title: Re: Need clutch reassembly info
Post by: 8683jb on March 22, 2020, 08:41:37 PM

The info you need is in TM 9-710 and TM 9-1711. I think you can see them both online as a pdf.

Jon