halftrackinfo

armor plate => front armor (doors forward) => Topic started by: steve-0 on October 22, 2010, 12:06:57 AM

Title: armor drawings for the doors
Post by: steve-0 on October 22, 2010, 12:06:57 AM

 it is reported these drawings may have mistakes i will delete this warning when dimensions have been verified  
i have not verified these dimensions myself, if you would like to add comments we would appreciate it. these drawings are the basic blanks. you will have to counter sink some of the holes  if you have an m2 you will need footman loop holes.
doors.... upper
http://i53.tinypic.com/33jmfec.jpg
http://i53.tinypic.com/soobnp.jpg
doors... lower
http://i55.tinypic.com/14163r7.jpg


the best way to make these is to locate a local laser or water jet cutting shop in your area (they are very common). check out some of there cut pieces to make sure you will be happy with the the finished product. they will have to write a program for the pieces and then just push a button. this is fairly inexpensive if you do all your pieces at once, and you will save alot on shipping.

Title: Re: armor drawings for the doors
Post by: Thomas on September 06, 2011, 11:59:12 AM

hello,

is the platte(door) the same for international ht? fit the dimensions?
thank you

Thomas

Title: Re: armor drawings for the doors
Post by: steve-0 on September 06, 2011, 08:29:19 PM

they are different.

Title: Re: armor drawings for the doors
Post by: bright87 on March 23, 2014, 03:42:47 AM

Why are there 4 holes for the latch- but only 3 items fit? (2 bolts and 1 handle). Whats the extra bolt hole for?

Title: Re: armor drawings for the doors
Post by: Cleprechaun on September 17, 2019, 02:35:06 PM

Does anyone have a new source for door armor drawings (upper/lower) ? The Tinypic.com site died 9/16/2019. Can you believe it. I missed getting upper door drawings by one day!

Title: Re: armor drawings for the doors
Post by: Prc148 on September 27, 2019, 05:39:16 AM

Message sent

Title: Re: armor drawings for the doors
Post by: bright87 on September 27, 2019, 10:17:56 PM

Here's are the tinypic drawings in pdf form.

Title: Re: armor drawings for the doors
Post by: bright87 on September 27, 2019, 11:03:37 PM

Here's the plate blueprints showing pistol port opening.

Title: Re: armor drawings for the doors
Post by: brit plumber on December 25, 2021, 09:43:51 AM

Can anyone confirm if the lower door dimensions are correct. Unfortunately Paul was out of lower doors so I’ll have to have some made temporarily out of 6mm steel and then hopefully buy some from Paul next time I’m over in the States.

Title: Re: armor drawings for the doors
Post by: brit plumber on November 04, 2023, 03:53:21 AM

Has anyone verified these dimensions yet? I’ve got Paul’s repro parts to fit to doors I’m having made from these drawings, but the latch dimensions appear to be out by up-to a 1/4” in places.

Title: Re: armor drawings for the doors
Post by: 8683jb on November 04, 2023, 01:46:01 PM

The dimensions shown on the lower door pdf by bright87 all match my original door. 

Jon