« previous next »
Pages: [1]

Author Topic: M2A1 PARTS NEEDED  (Read 2657 times)

N.H.H.

  • Newbie
  • *
  • Posts: 1
M2A1 PARTS NEEDED
« on: February 09, 2015, 11:42:15 AM »
I'm  looking  for  2  of  the  3  brackets  that  were  used  to  mount  the  pulpit  armor,  I  have  the  one  that  bolts  to  the  pole  on  the  back.  Also,  original  fuel  line  from  pump  to  carb  fuel  filter  and  oil  pan  drain  plug.

Thanks,
Neil
Logged

steve1973

  • Hero Member
  • *****
  • Posts: 1419
Re: M2A1 PARTS NEEDED
« Reply #1 on: February 10, 2015, 07:03:14 AM »
Superjeep is making a complete reproduction pulpit. You should contact him with the brackets you need. Don't forget the support brace in center floor to support the upright pole. The fuel line is simple to make. If you have a copy of the engine manual it shows photos of how the line is routed. You just need some tubing, ends and flaring tool and you are set. As for the oil plug, check with old big truck supply houses. If no luck check with the usual halftrack parts vendors. Someone should have this for you.

Steve A.
Logged
Pages: [1]
« previous next »