Front pinion seal

[emptyhead]

I’m replacing both pinion seals on the halftrack and did the rear but on the front I don’t see a seal for the seal housing in the base shop data book,but when I pulled the seal housing off it looks like there a thin cork gasket set in the bearing cage. Have you guys replaced this also with an o ring cut to fit or just used some gasket material in between the seal housing and the bearing cage. Sorry a lot of post lately, been checking off the punch list. Thanks

[steve1973]

FRONT AXLE – Timken
Bearings
   OUTER
      bearing     395A
      race          394A
   INNER
      bearing    33281
      race         33472
Seals
   front axle inner housing seal
      Timken or National   450291
   front axle pinion seal
      National   473215
   Front axle flange gasket
      Same as M35   7521787
   Steering knuckle boot
      Same as M35   7410883
   Large retaining ring clamp
      Same as M35
   Small retaining ring clamp
      Same as M35

Hope this helps.
Steve A.