Head bolt torque pattern?

[TBowman]

Hi all,

Getting ready to put the head back on my motor. Is there a torque pattern shown in the service manual?

Thank you
Tim

ps any help with torque specs on exhaust and intake manifold bolts would be greatly appreciated too.

[Smadge]

Here you go.

[Smadge]

There is a lot of discussion on the proper head bolt torque and i believe 70-75 ft lbs is correct.  Some of the TM's have a much higher, incorrect, torque.  I looked in my manuals and didn't see any specs on the manifolds other then tightening them down..

Paul

[TBowman]

Thank you both very much!!   I appreciate it.

Tim

[8683jb]

Tim -

As Paul said, be sure NOT to use the head bolt torque listed in TM 9-710. You can go online and look up a generic torque chart for the other various fasteners that don't show a torque value in the manual.

[Torque]

The civilian versions of the AX160 are the 150A, 250A, 450A, 460A and 462A. My 1967 Motors manual lists the head torque for all these civilian engines as 105-110 ft lbs and that is what I torqued my engine to.
 It lists intake and exhaust manifold bolt torque as 25-30.

[TBowman]

Thank you very much.

I read a few of the threads regarding those high torque numbers.  yikes!    Cant wait to get this thing bolted back together and fired up ***fingers crossed**

Thanks again for the helpful info.

Tim