« previous next »
Pages: [1]

Author Topic: brake control dash wiring terminal placement?  (Read 309 times)

mfrance

  • Full Member
  • ***
  • Posts: 187
brake control dash wiring terminal placement?
« on: October 20, 2023, 03:20:19 PM »
can anyone give me the color or wire # that goes to what terminals on each side of dash brake control are?

anyone also have a good photo of restored dash from backside with all wires and gauges in before they reinstalled into halftrack?

« Last Edit: October 20, 2023, 03:35:26 PM by mfrance »
Logged

Jesse

  • Full Member
  • ***
  • Posts: 110
Re: brake control dash wiring terminal placement?
« Reply #1 on: October 21, 2023, 02:46:47 AM »
I choose to leave the brake controller both electrically and mechanically disconnected on a halftrack. Anyone ever pull a trailer that used that type of brakes? The system is unfused. Both controller reostats are  on the fragile side. Mechanically, if something were to seize or get stuck in the controller, you wouldn’t be able to apply brakes at all. Leave it all disconnected. Eye candy only.
Logged

steve1973

  • Hero Member
  • *****
  • Posts: 1390
Re: brake control dash wiring terminal placement?
« Reply #2 on: October 21, 2023, 07:33:18 PM »
Hello Michael
If you have one of my M2 Base Shop Data Books the answer is in there, section 77. It shows the color , gauge and length of the wire. Hope this helps.



Steve A.
Logged

mfrance

  • Full Member
  • ***
  • Posts: 187
Re: brake control dash wiring terminal placement?
« Reply #3 on: October 22, 2023, 01:05:35 AM »
Thank you Steve.  I was to lazy to pull 1 out of my halftracks dash to answer a buddy question..
I'll forward info
Also yes I have your book and did not even look.. sorry
Logged
Pages: [1]
« previous next »