Guys, I have a question. I can't figure this out (in all honesty, I'm not too bright).
Trying to install my support roller on the drivers side. I just rebuilt the support roller assembly, with new bearings and gaskets. I have tightened the bolt on the shaft so that the gap between the mounting holes is EXACTLY what it was when I took the assembly off the top of the crab.
Well, as you can imagine, the two inboard bolts mount up without a problem. HOWEVER, the two outboard bracket mounting holes are about 1/4" off from the outboard crab installation holes.
I took an old support roller assembly, and it also doesn't line up.
Any thoughts on how I can bet these bracket mounting holes to line up with the crab mounting holes?
Thanks,
kk
