halftrackinfo

armor plate => m2/ m2A1 rear armor and bed => Topic started by: Torque on March 05, 2014, 08:04:00 PM

Title: Need some M2 rear compartment drawings
Post by: Torque on March 05, 2014, 08:04:00 PM

I need the drawings for the plates just to the rear of the troop seats that the fuel lines go down through. Also the left and right plates to the front of the seats that the ammo boxes set on (not the armor). Thanks to whoever this picture belongs to. Barry

Title: Re: Need some M2 rear compartment drawings
Post by: steve1973 on March 05, 2014, 08:07:15 PM

That is a picture on my floor. I will add it to the list of drawing to make. I'm still under the weather with a cold so be patient.
Thanks,
Steve A.

Title: Re: Need some M2 rear compartment drawings
Post by: Torque on March 05, 2014, 08:45:52 PM

Thanks Steve, no hurry. Your pictures are some of the best, a huge help. Thanks, Barry

Title: Re: Need some M2 rear compartment drawings
Post by: spec4don on March 06, 2014, 12:15:54 PM

Remember to put the floor plates in before you button up the back......Right Steve?

Don G.

Title: Re: Need some M2 rear compartment drawings
Post by: Torque on March 23, 2014, 10:01:56 AM

Steve,  If you get in the mood to measure stuff I also need the dimensions of that rear armor connector plate, the one in the photo between the lower and middle rear armor (don't need holes just overall). Thanks, Barry

Title: Re: Need some M2 rear compartment drawings
Post by: Sprouse on December 27, 2016, 04:41:29 PM

did you ever measure the lower bed out?

Title: Re: Need some M2 rear compartment drawings
Post by: steve1973 on December 27, 2016, 07:34:21 PM

Quote from: Torque on March 23, 2014, 10:01:56 AM

Steve,  If you get in the mood to measure stuff I also need the dimensions of that rear armor connector plate, the one in the photo between the lower and middle rear armor (don't need holes just overall). Thanks, Barry

Not sure which plate you are talking about.

Title: Re: Need some M2 rear compartment drawings
Post by: steve1973 on December 27, 2016, 07:36:14 PM

Quote from: Sprouse on December 27, 2016, 04:41:29 PM

did you ever measure the lower bed out?

I have no drawings of the sheet metal center area with the chain lockers. I tried to find someone to do this when I had it completely stripped down but no luck.

Steve A.