« previous next »
Pages: [1]

Author Topic: Dash  (Read 7954 times)

emptyhead

  • Hero Member
  • *****
  • Posts: 647
Dash
« on: March 09, 2014, 05:21:13 PM »
I'm working on getting the dash out but am having problem with the top armor bolts that go into the captured nuts underneath.have tried to get the armor bolts out with an electic impact gun and a ground down chisel but the bolts won't move. Put a little heat on but no luck. Any thoughts. Thanks guys
Logged

andy

  • Sr. Member
  • ****
  • Posts: 369
Re: Dash
« Reply #1 on: March 09, 2014, 06:22:16 PM »
I had same problem. I ended up cutting/torching the cage / nut and making a new cage with nut when I reinstalled
Logged
1943 M4A1 (restored to M2A1)

steve-0

  • Administrator
  • Hero Member
  • *****
  • Posts: 1385
Re: Dash
« Reply #2 on: March 09, 2014, 06:22:33 PM »
those are always stuck.
i just use a torch and cut the heads off. if you are good with a torch you can do it without damaging the armor.
if your not good with a torch just drill them out.
Logged

emptyhead

  • Hero Member
  • *****
  • Posts: 647
Re: Dash
« Reply #3 on: March 10, 2014, 03:32:16 AM »
Thanks guys
Logged

spec4don

  • Hero Member
  • *****
  • Posts: 981
Re: Dash
« Reply #4 on: March 10, 2014, 10:43:23 PM »
What I did was to drill the bolts drill a small pilot hole, then drill it the same diameter as a tap drill, the head will come off.

Don G.
Logged
1941 M2A1 not restored
1942 M3 Diamond T Mostly restored
1943 M3A1 Under restoration
1967 M51A2 Tractor
1945 WC 63 needs restoration
1967 M36 Long wheel base duece
1951 M135 GMC Fire truck conversion
Pages: [1]
« previous next »