Author Topic: M2 front platform plates  (Read 2311 times)

bright87

  • Full Member
  • ***
  • Posts: 137
M2 front platform plates
« on: May 17, 2014, 01:57:56 AM »
Hello all-
Does any one have the dimensions for the three plates that make up the front platform on a M2?
The two side plates sit partially under the ammo boxes, and the center is diamond plate.
Thanks-Michael

steve1973

  • Hero Member
  • *****
  • Posts: 1096
Re: M2 front platform plates
« Reply #1 on: May 17, 2014, 04:06:31 AM »
I will try and get measurements today. The two outer plates are part of the main floor. The driver's side plate has a hole in it for power wires for the radio to pass through to a junction box in the storage locker. Here are some photos that I had on file in the G503 albums. I will get more photos.

front -->




Steve A.

bright87

  • Full Member
  • ***
  • Posts: 137
Re: M2 front platform plates
« Reply #2 on: May 17, 2014, 07:19:02 AM »
Thanks Steve! I was wondering what that square hole was for.

steve1973

  • Hero Member
  • *****
  • Posts: 1096
Re: M2 front platform plates
« Reply #3 on: May 17, 2014, 03:28:54 PM »
Here you go.









Hope this helps.

Steve A.

Torque

  • Full Member
  • ***
  • Posts: 163
Re: M2 front platform plates
« Reply #4 on: May 17, 2014, 05:13:06 PM »
Thanks Steve, just what I needed. Are they all 1/8"?
   Barry

steve1973

  • Hero Member
  • *****
  • Posts: 1096
Re: M2 front platform plates
« Reply #5 on: May 17, 2014, 05:29:55 PM »
I believe so.

bright87

  • Full Member
  • ***
  • Posts: 137
Re: M2 front platform plates
« Reply #6 on: May 17, 2014, 06:22:35 PM »
Thanks Steve-now i can get to work!

Sprouse

  • Newbie
  • *
  • Posts: 45
Re: M2 front platform plates
« Reply #7 on: December 27, 2016, 04:12:30 PM »
steve do you have the lower bed measurements? track armor and compartments?
WC 63 Restored
M2 not restored
M2A1 early not restored
M2A1 late not restored
M2A1 late not restored

steve1973

  • Hero Member
  • *****
  • Posts: 1096
Re: M2 front platform plates
« Reply #8 on: December 27, 2016, 07:38:46 PM »
I have CAD files for all the rear side armor. I'm working with someone to convert them into drawings also. I will try to have something posted by spring.

Steve A.