I was asked to take some photos on how the fuel lines rout from the fuel selector block to the fuel tanks. I though I would post the photos here. As my halftrack, at least the rear portion, is assembles I had to be a little creative in getting the photos. All of my lines were made from remnants of the originals.
looking from the bottom up. Rubber line goes to fuel filter. Left line goes to driver's side tank and right line goes to Passenger's side tank. If you look at the brass plate on the shut off knobs you will not that left and right is reversed.
Another view with camera angled slightly back to see line routing. Lint on left goes to passenger's side tank and line on right goes to driver's side tank.
This photo you see the line on the right, driver's side tank, going through the inboard of the two larger holes leading into the drivers side storage compartment. One other thing to note is that the sending unit wiring follows the same rout for each side tank. I havn't gotten that far with my wiring yet. The out board hole is for the power lines in the metal conduit for the radio junction box.
This is the left line going through the hole leading into the passenger's side storage compartment.
This is the driver's side compartment towards the front. You now see the line coming in bending upwards and runs along the top towards the rear. This is the same routing for the passenger's side.
This is the driver's side compartment facing the rear. You see the line at the top going to the end then a 90 degree bend. At this point a flex line is attached going through a small opening to the fuel tank. Again, this is the same routing for the passenger's side and the sending unit wire runs in the same path.
Steve A.
